Juniper MX960 version 18.4R3
I had a flap of a whole MPC 3D 16x 10GE.
The router is terminating DHCP clients ~25k. ~45Gbit traffic go thru.
This is the first time that happened
I have attached logs
I would be very appreciated of any advice
Hi, these logs matched to one of internal PR , you can open case to JTAC and they will recommend you sw version where this PR fixed
P.S. MPC 3D 16x 10GE is not officially supported for Subscriber Management
Could you tell me the content of the PR and recommended version?
I do not have access to JTAC
I would be very pleased