Junos OS

Expand all | Collapse all

Support MX-SPC3 on SCBE3

Jump to Best Answer
  • 1.  Support MX-SPC3 on SCBE3

    Posted 10-03-2020 00:45

    Hi

    Based on Juniper BNG configuration, for having L4 Redirection service on BNG Subscribers, we may need to use MX-SPC3. I want to use following cards in my setup:

    1- MPC10E-10C-BASE

    2- MPC7EQ-10G-RB

    3- SCBE3-MX-BB

    Based on hardware tool MX-SPC3 is support on SCBE2 and SCBE only and it is not supported on SCBE3. Do I need to use this card on the planned cards when we want to have L4 Page Redirection while I don't want to use RE-Based redirection?

    Thank you

    Alireza

     



  • 2.  Re: Support MX-SPC3 on SCBE3

    Posted 10-03-2020 03:14

    There is no support for SPC3+MPC10+SCBE3 right now, but it is planning for future releases.



  • 3.  Re: Support MX-SPC3 on SCBE3

    Posted 10-03-2020 03:32

    HI

    So this simply means, I have to use L4 Redirection in RE mode with this setup. Correct?

    I assume RE mode will have a negative effect on device performance.

    Best Regards

    Alireza



  • 4.  Re: Support MX-SPC3 on SCBE3
    Best Answer

    Posted 10-03-2020 03:57

    There is should not be any impact on RE, especially if you will configure ddos-protection with flow-deletection enabled



  • 5.  Re: Support MX-SPC3 on SCBE3

    Posted 10-04-2020 04:11

    Hi

    Thank you for the Answer