Switching

Expand all | Collapse all

EX2300-48P POE MODE Issue

Jump to Best Answer
  • 1.  EX2300-48P POE MODE Issue

    Posted 04-16-2019 00:02

    Hello,

    I would like to know if it is possible to change the POE Mode on my  juniper switch EX2300-48P from 802.3at to 802.3af. I am trying to configure an access point which supports only 802.3af.

    From what i have searched, 802.3at covers 802.3af. But I don't see any thing on the port or APoint.

     

    Here are a few details if that might help:

    admin@sw-jun-poc-2> show poe interface ge-0/0/6
    PoE interface status:
    PoE interface : ge-0/0/6
    Administrative status : Enabled
    Operational status : OFF
    Operational status detail : Detection In Progress
    FourPair status : Disabled
    Power limit on the interface : 15.4W
    Priority : High
    Power consumed : 0.0W
    Class of power device : not-applicable
    PoE Mode : 802.3at

    ############################

    admin@sw-jun-poc-2> show interfaces ge-0/0/6 brief
    Physical interface: ge-0/0/6, Enabled, Physical link is Down
    Link-level type: Ethernet, MTU: 1514, LAN-PHY mode, Speed: Auto, Loopback: Disabled, Source filtering: Disabled, Flow control: Disabled, Auto-negotiation: Enabled, Remote fault: Online,
    Media type: Copper, IEEE 802.3az Energy Efficient Ethernet: Disabled, Auto-MDIX: Enabled
    Device flags : Present Running Down
    Interface flags: Hardware-Down SNMP-Traps Internal: 0x4000
    Link flags : None

    Logical interface ge-0/0/6.0
    Flags: Device-Down SNMP-Traps 0x24024000 Encapsulation: Ethernet-Bridge
    eth-switch

     

    Thank you. 🙂



  • 2.  RE: EX2300-48P POE MODE Issue
    Best Answer

    Posted 04-16-2019 05:14

    ## Solution FOUND!##

    The issue was with my access point (old hardware), another access point(same model) with revised 'date code' works perfectly on same configurations.

    Ref: Unifi Access Point (UAP-AC-LR).