In case you didn't find it you save a rescue configuration with
request system configuration rescue save
This is only used in corruption and reboot scenarios. And should be kept up to date as the configuration changes over time.
------------------------------
Steve Puluka BSEET - Juniper Ambassador
IP Architect - DQE Communications Pittsburgh, PA (Metro Ethernet & ISP)
http://puluka.com/home------------------------------
Original Message:
Sent: 10-24-2021 03:38
From: Unknown User
Subject: SRX4100 Status and SSD LED Blinking Red and Green
Hello spuluka
thank you, yes "show system alarm" works.
Due to lack of rescue configuration.
Regards,
Amir
Original Message:
Sent: 10-04-2021 05:38
From: STEVE PULUKA
Subject: SRX4100 Status and SSD LED Blinking Red and Green
Also check on these status commands
show system alarms
show chassis cluster status
------------------------------
Steve Puluka BSEET - Juniper Ambassador
IP Architect - DQE Communications Pittsburgh, PA (Metro Ethernet & ISP)
http://puluka.com/home
Original Message:
Sent: 10-02-2021 07:35
From: Unknown User
Subject: SRX4100 Status and SSD LED Blinking Red and Green
Hello Dear
I have two SRX4100 that in Cluster Mode, the front Status and SSD LED of primary node blinking Green and Red. every thing work fine.
I don't have any alarm from cli check command such as "show chassis alarm" and " show chassis raid status"
I can't find any document that explain this state.
I reboot the both node but nothing happen and after both node comes up the primary node LED (Status and SSD) start blinking in Green and Red.
I would be appreciate if someone can explain this state or send me the reference link.
you can check the below video for the LED status
SRX4100 LED blinking
Thank you
Amir