SRX

 View Only

IMPORTANT MODERATION NOTICE

This community is currently under full moderation, meaning  all posts will be reviewed before appearing in the community. Please expect a brief delay—there is no need to post multiple times. If your post is rejected, you'll receive an email outlining the reason(s). We've implemented full moderation to control spam. Thank you for your patience and participation.



LACP between Juniper vSRX and Cisco Nexus 9000

This thread has been viewed 4 times
  • 1.  LACP between Juniper vSRX and Cisco Nexus 9000

    Posted 04-04-2022 05:42
    Hi Everyone,

    Is it really possible de set LACP for LAG  between Juniper SRX firewall and  Cisco Nexus ? 
    Actually I'm working on below LAB with port aggregation between Nexus and vSRX.
    For Juniper side I used Aggregate Ethernet ae0 interface (ge-0/0/4 and ge-0/0/5) and for Nexus side I used port channel interface (E1/4 and E1/5).
    Active mode for Nexus and Passive mode for Juniper.


    When I enable LACP on each aggregate interface automatically both ae0 et port channel interface are on protocole  mode DOWN.
    By troubleshooting I could see that Nexus interface are on suspended mode because they didn't receive LACPDU reply from peer. 
    No any LACP statistics information is available for vSRX.

    When I put vSRX LACP on active mode I can see transmission query counter but no any reply information from Nexus: 

    root# run show lacp statistics interfaces ae0

    Aggregated interface: ae0
                LACP Statistics: LACP Rx              LACP Tx         Unknown Rx          Illegal Rx
                       ge-0/0/3                         0                          386                                0                            0
                       ge-0/0/4                         0                         386                                 0                            0


    Once I disable LACP both aggregate interfaces are UP and I provide reachability between device.
    this issue is same white Reth interface for SRX Cluster device.

    So I want to know if LACP between Juniper and other vendor is possible or if I make some mistake let me know.

    Thanks Expert for your support.


    ------------------------------
    WYA ABU
    ------------------------------