My recollection is that with transparent mode all interfaces are the same vlan and tags are no longer relevant. This just becomes a bump in the wire allowing rules within that vlan.
Can you share the document you used to configure transparent mode.
Then the specific traffic failure that is happening between ports.
------------------------------
Steve Puluka BSEET - Juniper Ambassador
IP Architect - DQE Communications Pittsburgh, PA (Metro Ethernet & ISP)
http://puluka.com/home------------------------------
Original Message:
Sent: 11-13-2021 07:30
From: saifuddin miyaji
Subject: SRX1500 Transparent Mode - VLAN1
We have been trying to deploy SRX1500 in transparent mode. We are facing issue with VLAN 1.
We have been using the default VLAN i.e. VLAN 1 for some significant communication and cant remove it overnight. In transparent mode, we are not able to pass the VLAN 1 traffic through the firewall. Several configurations have been tried.
Is there any limitation as such that we cant use VLAN 1 with SXR transparent mode.
Saif
------------------------------
saifuddin miyaji
------------------------------