Hi Austin,
That is a very interesting proposition. I am not sure anyone has tried it. This is likely applicable more if you have a two node HA SSR and WireGuard associated at both WAN interfaces. Have you tried it?
------------------------------
Mark Ansley
------------------------------
Original Message:
Sent: 02-24-2023 13:49
From: Austin
Subject: WireGuard Plugin walkthrough
Great walkthrough, thank you very much!
At 5 minutes in, you associate the WireGuard Profile with a WAN interface. Are you able to apply the WG Profile to a second WAN interface, for redundancy? Say you had dns records pointing to both public WAN IPs, to allow clients load balance and fail over if one WAN connection was to fail.
------------------------------
Austin Stoffel
Systems Administrator
Original Message:
Sent: 11-28-2022 14:13
From: Mark
Subject: WireGuard Plugin walkthrough
Hello Community,
I have put together a quick walkthrough covering the configuration of WireGuard on your SSR. It is not an all inclusive video, but merely a basic configuration. It is also my first video on the community. I hope to contribute more in the future.
All documentation can be found here:
Wireguard Plugin | SSN Docs
| Juniper |
remove preview |
|
| Wireguard Plugin | SSN Docs |
| The wireguard plugin allows your 128T router to peer with other endpoints using wireguard. With this plugin you can securely connect endpoints to your 128T fabric, extending services and network tenancy. Wireguard operates using cryptokey routing, which provides device-to-edge security with a 128T service centric fabric. |
| View this on Juniper > |
|
|
Quick note, at some point in the video I mistakenly refer to public address instead of public key.
------------------------------
Mark Ansley
------------------------------