Routing

Hi Team,

I am looking to configure a bridge domain on MX480, to establish comms between a trunk port on the carrier side, and an access port on the internal side. 

Internal side => Access port ge-2/0/1

set interfaces ge-2/0/1 encapsulation ethernet-bridge
set interfaces ge-2/0/1 unit 0 family bridge vlan-id 151

External => VLAN tagged traffic
set interfaces xe-0/0/5 flexible-vlan-tagging
set interfaces xe-0/0/5 encapsulation flexible-ethernet-services
set interfaces xe-0/0/5 unit 151 vlan-id 151
set interfaces xe-0/0/5 unit 151 family bridge

set bridge-domains BD-151 domain-type bridge
set bridge-domains BD-151 vlan-id 151
set bridge-domains BD-151 interface ge-2/0/1.0
set bridge-domains BD-151 interface xe-0/0/5.151

However, the commit fails with the below message.

# commit check 
re0: 
error:  To configure family bridge on an interface , interface mode (access or trunk) should be specified
error: configuration check-out failed

If I manually set the interface to "access" then it complains about the BD which I believe is a Trio limitation.

commit check 
re0: 
[edit bridge-domains BD-151 interface]
  'ge-2/0/1.0'
    Interface with 'interface-mode' is not allowed in a bridge-domain
error: configuration check-out failed: (statements constraint check failed)

Not sure what I am missing here. Can someone what's causing it and how to accomplish this L2 stitching on MX please?

Hi team,

The issue got resolved on review after applying the missing line of configuration.

set interfaces xe-0/0/5 unit 151 encapsulation vlan-bridge

------------------------------
SOHAN SINGH
------------------------------