This message was posted by a user wishing to remain anonymous
I am looking to configure a bridge domain on MX480, to establish comms between a trunk port on the carrier side, and an access port on the internal side.
Internal side => Access port ge-2/0/1
set interfaces ge-2/0/1 encapsulation ethernet-bridge
set interfaces ge-2/0/1 unit 0 family bridge vlan-id 151
External => VLAN tagged traffic
set interfaces xe-0/0/5 flexible-vlan-tagging
set interfaces xe-0/0/5 encapsulation flexible-ethernet-services
set interfaces xe-0/0/5 unit 151 vlan-id 151
set interfaces xe-0/0/5 unit 151 family bridge
set bridge-domains BD-151 domain-type bridge
set bridge-domains BD-151 vlan-id 151
set bridge-domains BD-151 interface ge-2/0/1.0
set bridge-domains BD-151 interface xe-0/0/5.151
However, the commit fails with the below message.
# commit check
error: To configure family bridge on an interface , interface mode (access or trunk) should be specified
error: configuration check-out failed
If I manually set the interface to "access" then it complains about the BD which I believe is a Trio limitation.
[edit bridge-domains BD-151 interface]
Interface with 'interface-mode' is not allowed in a bridge-domain
error: configuration check-out failed: (statements constraint check failed)
Not sure what I am missing here. Can someone what's causing it and how to accomplish this L2 stitching on MX please?