Log in to ask questions, share your expertise, or stay connected to content you value. Don’t have a login? Learn how to become a member.
I recently bought one Juniper Controller WLC 2800 / MX 2800.
The ROOT password can't be provided because it's not known, this was purchased from Ebay.
The controller is working, NO bad status - everything is fine.
In order for me to reset the Root password I have to get in into the Loader mode.
To interrupt the Boot sequence at the beginning right after I'm plugging in the Juniper WLC 2800 with the power cord and follow the screen being connected Via Serial Connection using Serial Port and PUTTY on Serial connection.
The Juniper console is working just that I have the following problem:
- No prompt for choosing Space Bar at the beginning in order for me to go on the Loader mode and run the commands for the Root Reset procedure starting with "boot -s" and so on.
- Instead the only prompt showing is for the Boot mode - Q plus Enter.
- The controller only starts in BOOT mode by pressing Q plus Enter.
I tried different methods, cables, other buttons and so on - nothing - I cannot enter in the Loader mode.
In the past I used the exact same process to configure other two controllers, everything worked fine!
- Why don't the Controller prompts for Space before the booting sequence?
- Does anyone know how to get into the Loader mode in this case?
The only mode I can get in is the Boot Mode which is limited with some commands that allowed me to change the Boot Default and so on - I tried, I changed the default Boot from 1 to zero - loading another image but it's the same! I changed it back to default.
Nothing relevant via the Internet Research, just that it could be in the Boot Mode and something related to Jtac.
Video and images: https://s.go.ro/b9zmyk5e - LINK OK / secure!
Hi, I can't see too much things on your video unfortunately, but if you don't need the current config at all, try to make a bootable usb with the... Earn 6 Juniper certifications.Free training/Discounted exams Junos OS Post New Message Re: Juniper MX 2800 / WLC 2800 - CLI Password Reset - Space not prompting Reply to Group Reply to Sender Dec 28, 2022 7:27 AM BALAZS KISS Hi,I can't see too much things on your video unfortunately, but if you don't need the current config at all, try to make a bootable usb with the requested junos, boot from there, install it and you won't need password recovery then.------------------------------BALAZS KISS------------------------------ Reply to Group Online View Thread Recommend Forward Flag as Inappropriate
Original Message:Sent: 12-26-2022 03:17 You are receiving this message because you followed the 'Juniper MX 2800 / WLC 2800 - CLI Password Reset - Space not prompting' message thread. To unsubscribe from this message thread, go to Unsubscribe. Update your email preferences to choose the types of email you receiveUnsubscribe from all participation emails
Update your email preferences to choose the types of email you receive
Unsubscribe from all participation emails