Switching

 View Only
last person joined: 22 hours ago 

Ask questions and share experiences about EX and QFX portfolios and all switching solutions across your data center, campus, and branch locations.
  • 1.  ex2300 virtual chassis rebooting

    Posted 12-27-2022 10:19

    Hello, 

    we know, that in a virtual chassis, when one member is removed or fails, the other member will become the master.
    in my case, let's say sw1 and sw2 , sw1 as master and sw2 as member, when sw1 as master is removed or fails automatically sw2 will become the master, and when sw1 is added again, sw1 and sw2 will reboot, this is very annoying if implemented in procution, is it really like this?

    Thank's



    ------------------------------
    A. YAHYA HUDAN PERMANA
    ------------------------------


  • 2.  RE: ex2300 virtual chassis rebooting

    Posted 12-27-2022 14:55
    I am not sure, but I can't remember having seen this behaviour. At least
    when the same unit is replaced. If you have another (new) unit, it may
    be different, you'll need to adjust the (preprovisioned) vc
    configuration then.




  • 3.  RE: ex2300 virtual chassis rebooting

    Posted 12-28-2022 07:27

    Hmm, I don't know.. but the unit I replaced was the same unit and without any changes,

    the problem was the new unit or the same unit when I put it back in, they would still rebooting



    ------------------------------
    A. Yahya Hudan Permana
    ------------------------------



  • 4.  RE: ex2300 virtual chassis rebooting

    Posted 12-28-2022 07:34
    Is the replacement switch confirmed running the same version of Junos as the device still in the cluster?

    ------------------------------
    Steve Puluka BSEET - Juniper Ambassador
    IP Architect - DQE Communications Pittsburgh, PA (Metro Ethernet & ISP - Retired)
    http://puluka.com/home
    ------------------------------



  • 5.  RE: ex2300 virtual chassis rebooting

    Posted 12-28-2022 20:12
    yes of course,
    Maybe I can explain and be more detailed.
    so as i explained before, i have 2 switches which have same version and same configuration, then i configure using virtual chassis to lacp to a router, then i try to unplug one switch to see if virtual chassis is running or not, and it happens That's something I've explained before.
    I'm sorry, I'm still early on this, so it's hard for me to explain

    ------------------------------
    A. Yahya Hudan Permana
    ------------------------------



  • 6.  RE: ex2300 virtual chassis rebooting

    Posted 12-29-2022 02:46
    Hi,

    Please put no-split detection knob. Please make sure u power off first switch and connect VC link before u power on switch. After that then u can power on.


    Thanks