Switching

Ambuj, Yes, COA is supported on the EX4300 with Junos 17.3R1 and newer. Please see the Pathfinder link to verify the feature is supported. https://apps.juniper.net/feature-explorer/feature/1424?fn=Port%20bounce%20with%20CoA%20requests%20and%20framed-IPv6-address%20RADIUS%20attribute%20for%20AAA ...

Does Juniper EX 4300 supports change of authorization (COA) for reauthentication of an active session in a radius server ? If Yes, is there a certain code version switch need to be on ? please share a supporting document if possible, I looked through ...

Hi, we try to connect EX4650 with EX4100-48P by SFP28 using SFP-25G-LR-C That message we got on EX4100. Junos version 22.3R1.12 what could be the issue for SFP receive power low alarm set ? Cable Optic distance is about 200-400m. All of 47 pcs ...

Hi Sanjar, You don't need to add any config onto member 1 or any other member you want to add, although that won't hurt and will be just over writen. The reason they are not joining is because you need to add "member 1 { role routing-engine; ...

your config on the 2 boxes should be the same in a virtual chassis (since it's the same management plane). So you'll need to have both members in the VC segment. ------------------------------ Allyn Crowe ------------------------------

I would like to whitelist the IP addresses on the aggregated interface. I've done the configure on EX4200 and it works as expected. This is what I've done on EX4200: > show configuration interfaces ae11 aggregated-ether-options { lacp { ...

An example that would block inbound ntp requests to the switch and allow all other into switch traffic. set firewall family inet filter ntp term block-ntp from protocol udp set firewall family inet filter ntp term block-ntp from destination-port ...