Switching

Hi Sanjar, You don't need to add any config onto member 1 or any other member you want to add, although that won't hurt and will be just over writen. The reason they are not joining is because you need to add "member 1 { role routing-engine; ...

your config on the 2 boxes should be the same in a virtual chassis (since it's the same management plane). So you'll need to have both members in the VC segment. ------------------------------ Allyn Crowe ------------------------------

I would like to whitelist the IP addresses on the aggregated interface. I've done the configure on EX4200 and it works as expected. This is what I've done on EX4200: > show configuration interfaces ae11 aggregated-ether-options { lacp { ...

An example that would block inbound ntp requests to the switch and allow all other into switch traffic. set firewall family inet filter ntp term block-ntp from protocol udp set firewall family inet filter ntp term block-ntp from destination-port ...

Hello everyone, I try to work with Juniper first time. Need help with virtual-chassis. I made all like in this video https://www.youtube.com/watch?v=1OWljMuijq4 but it doesn't work. Conf of slave switch is below root@SLAVE# show ## Last changed: ...

I'd like to echo the previous request. Could you share the configuration that kept the switch from responding to mode 6 queries, but still allowed internal NTP traffic to pass through? ------------------------------ SWARUP GUPTA ------------------- ...

Hi, Configuration looks OK. To me, most probably it is because of how routers are connected in the background. ------------------------------ FARID AKHUNDOV ------------------------------