Switching

Hi Jonathan, Maybe you could add a route like this on switch 1 and switch 2: set routing-options static route 0.0.0.0/0 next-hop 10.1.101.1 That would impact traffic on the DCMgmt vlan but would not impact traffic flowing through the switch on other ...

That is right, on access ports you can set one VLAN as member, try one with IRB so you can ping EX4300 from laptop on IP .3 for example. i.e port 22 vlan 20, port 23 vlan 24 etc then your trunk port 24 device , i.e router would have .1/24 IP you ...

I tested this in a lab but nobody recommended it for prod: A1-LAB> show configuration interfaces et-0/0/31 description "c03 / virtual"; flexible-vlan-tagging; native-vlan-id 10; mtu 9216; encapsulation flexible-ethernet-services; unit 10 { description ...

Can you please tell me if EX4300 works with OSPF by default or do I need to buy a license? ------------------------------ Pavel Guegan ------------------------------

I have two EX4100s in a VC that are handling routing for a building. There are other EX4100s in different closets around the building that are trunking all VLANs to the VC. VC <-fiber-> Switch1 <-fiber-> Switch2 <-fiber->Back to VC. The VC has fiber ...

@Rene1 1 Thanks! So just to be sure I set everything correctly when EX4300 arrive. First we set port 24 as a "trunk", so we add proper description and set it to trunk: set interfaces ge-0/0/24 description "UPLINK port to modem_router_switch" ...

Hi Bart This is a config you could use Below set up port 24 as trunk You can replace with your own VLANs set interfaces ge-0/0/24 description "Uplink to router_switch" set interfaces ge-0/0/24 unit 0 family ethernet-switching interface-mode ...