View Only
last person joined: yesterday 

Ask questions and share experiences about EX and QFX portfolios and all switching solutions across your data center, campus, and branch locations.

If you have a question or a use case, there are likely others experiencing or who worked through the same thing. Don't hesitate to jump in and ask or share your knowledge!

Need additional guidance?  Check out these Juniper Resources.

Documentation Knowledge Base Day One Books Free Trial

Latest Discussion Posts

  • This message was posted by a user wishing to remain anonymous We have seen similar a few years back when running 14.1X53-D30, with backup RE memory usage slowly escalating while primary RE is ok. Try "show system memory" to get a better idea about how ...

  • Thanks mate you save my day. USB should be connected before the switch start. ------------------------------ MOHAMMED MASI ------------------------------

  • Yes, if the EX3400 (or any switch doing IGMP snooping) sees an mrouter on one interface (that is, sending IGMP membership queries , PIM packets, or whatever) inside a vlan, it will sends it all the multicast flows present in the vlan, as this is by design ...

  • Hi Spuluka, Thanks for the reply. The Junos version is 18.1R3-S6 Is the problem resolved in Junos 20.4R3-S5.4? Thank you so much for your support, Thuy. ------------------------------ Jasmine Phan ------------------------------

  • Thanks again! But to confirm, even if each QFX was part of a PIM-SM network, any 3400s connected to that QFX would send every multicast source on the 3400 up to its QFX? Or would PIM at the aggregation layer somehow be able to prevent that? Currently ...

  • thanks !!

  • thanks so much !! Basically I like to know what causes these two different outputs, platforms ? configuration ? I was trying to locate one MAC, I noticed these two outputs from different switches in EVPN/vXLAN fabrics. I like to know why. Also ...


Unanswered Posts

Top Contributors in the Community