View Only
last person joined: 2 days ago 

Ask questions and share experiences about EX and QFX portfolios and all switching solutions across your data center, campus, and branch locations.

If you have a question or a use case, there are likely others experiencing or who worked through the same thing. Don't hesitate to jump in and ask or share your knowledge!

Need additional guidance?  Check out these Juniper Resources.

Knowledge Base Day One+ Technical BulletinsFree Trial

Latest Discussion Posts

  • Hi Spuluka Big Thanks for your reply . We have already reformatted the switch for now . I will try the same in the next switch if i get the same issue . ------------------------------ Rahul Aswal ------------------------------

  • Profile Picture

    RE: Error while Committing

    You could try loading the factory default configuration then setting the root password. load factory-default ------------------------------ Steve Puluka BSEET - Juniper Ambassador IP Architect - DQE Communications Pittsburgh, PA (Metro Ethernet ...

  • When did the snapshot feature change for the EX4600 and EX4300's? Was it hardware, or JUNOS "enhancements"?

  • Hi Todd Thanks for your reply . Its a version 12.0 old switch with NO configuration and one of our Field engineer was trying to set root authentication password to it . However, the device is showing that attached error . On further troubleshooting ...

  • Hi, There is no alternative partition to snapshot on the EX4600 and EX4300-MP devices. The EX4600's let you snapshot to a USB drive and the EX4300-MPs don't support the snapshotting feature. Many Thank ------------------------------ HARRY --- ...

  • The basic point of having QoS is to prioritize traffic when they hit links that will be over capacity so you make sure the right flow is first in line or that a big flow does not kill everything else. In the network you describe where this is only configured ...

  • This message was posted by a user wishing to remain anonymous Hi, I'm trying to better understand how CoS is applied on the network and at which nodes in the network they're meant to be configured. Currently, the network I'm trying to tweak is composed ...


Unanswered Posts

Top Contributors in the Community