Switching

Hi Community, I could see the following logs often from several switches. It shows only VLAN ### (native): Mar 15 07:29:06 SWITCH-A l2ald[9147]: L2ALD_MAC_MOVE_EXCEEDED_BD: Limit on MAC moves exceeded at VLAN Dxxx + ### for MAC aa:bb:cc:dd:ee:ff ...

What traffic is too slow and where is the other endpoint? Or is the admin access interface problem? If there is a general connectivity with all connected devices there might be a layer 2 loop where two ports in the same vlan are accidently connected. ...

Hello , If my Switch is too slow where do I have to search ? I really need help to find where to search ? Best Regards ------------------------------ Zurratos Zurratos ------------------------------

From the description it seems likely this is hardware failure. You should open a ticket with support, I think these are covered for hardware issues like that and would likely be replaced. ------------------------------ Steve Puluka BSEET - Juniper ...

Thanks for your reply. Unfortunately, the ctrl +c combination doesn't affect this behavior. It keeps rebooting. It stops at the dram initialization, which is not stated in any of the article cases. I hope this is not a hardware failure as ...

I have a problem with high CPU and memory usage seen in routing engines of both EX4600 that are stacked in VC and both are on newest/recommended Junos version 21.4R3-S2.4 Result of this problem is slow response of ssh and very high latency when pinging ...

You can try these methods to recover from this boot loop. https://supportportal.juniper.net/s/article/EX-Recovering-EX-switch-when-it-cannot-get-into-loader-prompt ------------------------------ Steve Puluka BSEET - Juniper Ambassador IP Architect ...