Switching

Its been a while since I equipped and configured ports on a couple of these. I need to add a couple of non-channelized 40GE qsfps and although I have this set, with 1 of these: QSFP+40GE-LX4, the h/w does not show up. set chassis fpc 1 pic 0 port ...

I have 4 sites that show a switch or device not under the core fiber switch in the Topology view. Two are switches, one is an IP camera, and one is a Dell computer. Nothing but switches are connected to the core fiber switch so the topology should flow ...

I've revisited all the switches that are not shown properly in the Mist "Topology" view, this morning. All of them do see their neighbors. They just have incorrect layouts in the Topology view. All my sites should have the MDF as the top of the tree, ...

All of our switches have the following setting by using switch templates: set protocols lldp port-id-subtype interface-name set protocols lldp port-description-type interface-alias set protocols lldp interface all set protocols lldp-med interface ...

This message was posted by a user wishing to remain anonymous - see below from Jtac 'this behavior is matching an internal confidential PR which does not have a specific release fixreported. Strange log messages are been noticed ...

I would start by confirming the lldp status on the affected switches show lldp neighbors And if the neighbors are indeed not up and running, confirm that both the interfaces and the lldp protocol sections are complete on the both adjacent switches ...

Hi, It looks like you've set up your regex filter correctly for matching the log messages. However, to ensure that the matched log entries are sent to your syslog server, you'll need to make sure that your system is correctly configured to forward the ...