Switching

good insight into Junos's port mirroring capability!👍 now i don't have to try interop with IOS XE switch. while wireshark can decode GRE fine, some network visibility tools may not. this is why i need to take the switch capability into ...

Encap yes, decap no. Junos wraps mirrored traffic in plain GRE with the analyzer output ip-address config, and the docs are explicit that the end device is expected to strip the encapsulation itself. There's no equivalent of the IOS XE erspan-destination ...

Hi, it seems like you're expecting autocompletion for any interfaces (at least those visible in `> show interfaces terse`) when using `# set interfaces ?`-but no, that's not the case. Autocompletion-or rather, a hint-indicates that an interface previously ...

Hi Annie, I'm seeing a similar issue on an ex3400 virtual chassis. Were you able to find any solutions? Jul 24 03:18:00 TelephoneRM-EX3400 dc-pfe[20592]: PoE: Failed to read voltage measurements Jul 24 03:18:00 TelephoneRM-EX3400 fpc0 PoE: Failed ...

in Junos switches (and some routers), you can configure ERSPAN as below to encapsulate mirrored traffic in GRE. analyzer { a1 { input { ingress { interface ge-0/0/1.0; } } output { ...

Hi I think that autocomplete only work when you already configured the IF. For example, my QFX displays as follows: # set interfaces ? Possible completions: <interface-name> Interface name ae2 ...

Hi! Thank you much for detailed explanation. I was pretty sure that hints are based on physical interface presence rather than on existing config for this interface. Thx once again. ------------------------------ Alex Kabachok --------------- ...