Switching

Hello experts, I recently tried to use input-vlan-map and pop-swap on one of our QFX5120-48Ys, and while the command the accepted the logs showed the platform didn't support this feature. A couple of questions do you think this can ever be supported ...

To see if you actually need QoS in the first place, look at the tail drops. Here is a neat way of doing it that works in the EX3400 at least: > show interfaces ge-* extensive | match "Physical|^( +[0-9]+)+ *$" | except " 0$|Down" Physical interface: ...

Try "request system snapshot recovery" instead of it. ------------------------------ BALAZS KISS ------------------------------

I don't believe there was ever an option for snapshotting internally on the EX4600 and EX4300-MP. Snapshotting is available on the standard EX4300's just not the Multigig ones. ------------------------------ HARRY ------------------------------

Hi Spuluka Big Thanks for your reply . We have already reformatted the switch for now . I will try the same in the next switch if i get the same issue . ------------------------------ Rahul Aswal ------------------------------

You could try loading the factory default configuration then setting the root password. load factory-default ------------------------------ Steve Puluka BSEET - Juniper Ambassador IP Architect - DQE Communications Pittsburgh, PA (Metro Ethernet ...

When did the snapshot feature change for the EX4600 and EX4300's? Was it hardware, or JUNOS "enhancements"?