Switching

 View Only
last person joined: 6 days ago 

Ask questions and share experiences about EX and QFX portfolios and all switching solutions across your data center, campus, and branch locations.

If you have a question or a use case, there are likely others experiencing or who worked through the same thing. Don't hesitate to jump in and ask or share your knowledge!

Need additional guidance?  Check out these Juniper Resources.

Ask AI Documentation Knowledge Base Day One Books Free Trial

Latest Discussion Posts

  • Hi, I have a QFX10002-36Q, and I configured sFlow with the following commands: set protocols sflow polling-interval 20 set protocols sflow sample-rate ingress 10000 set protocols sflow source-ip 10.x.x.246 set protocols sflow collector 172.x.x.210 set ...

  • I'll try that out on some random switches that I get alerts saying they are in the high range. ------------------------------ JOHN WILLIAMSON ------------------------------

  • This kb for evaluation of potential EX switch causes for high CPU and filters to block the traffic causing the increases. https://supportportal.juniper.net/s/article/EX-Troubleshooting-and-resolving-high-CPU-utilization-on-EX4300?language=en_US ...

  • Start by identifying which process: To show software processes: Make sure you are in operational mode. Enter the 'show system processes extensive' command. This command shows the CPU utilization on the device and lists the processes in order of ...

  • I noticed a switch in the Mist dashboard that indicated the CPU was well up in CPU utilization. Indocator was red. SO I checked the CPU with the show chassis routing-engine command and got this report: show chassis routing-engine Routing Engine ...

  • Profile Picture

    vQFX ping failed

    Should be a simple question, maybe I missed something and need help desperately. Setting up vQFX with either 17.4 or 18.4 image within eve-ng, but never able to ping across the link. What did I miss vQFX: delete interface set interfaces em1 unit 0 ...

  • Yes. VLAN2 is our main staff VLAN and is one of the default VLANs applied to every switch. All the APs are on trunk ports that allow all the VLANs. The native VLAN for the APs is our management VLAN 130. ------------------------------ JOHN WILLIAMSON ...

Announcements

  • Tell us if you've upgraded or if you need help upgrading

    Complete this three-question survey to help us identify where you are in your upgrade journey.

Unanswered Posts

Top Contributors in the Community