Switching

 View Only
last person joined: yesterday 

Ask questions and share experiences about EX and QFX portfolios and all switching solutions across your data center, campus, and branch locations.

If you have a question or a use case, there are likely others experiencing or who worked through the same thing. Don't hesitate to jump in and ask or share your knowledge!

Need additional guidance?  Check out these Juniper Resources.

Knowledge Base Day One+ Technical BulletinsFree Trial

Latest Discussion Posts

  • Hi, I can see your juniper devices are in a VC(virtual chassis) you can configure link aggregation which will bundle both links into one which will give you bandwidth by merging both interface as well if one link goes down other will be still working. ...

  • I have a pair of ex4300s that don't appear to be installing entries sourced from the TCAM table... at least, I don't think so based on outputs. I came upon this wondering why our loopback firewall filter wasn't working. ====================== Filter ...

  • Hi, If u do bundle then u can make it active-passive physical. Thanks

  • After further review, the above configuration is removing the inner tag. What needs adjusted to retain this? Both tags are ether-type 0x8100. ------------------------------ Dan Graham ------------------------------

  • Hello , I have two ports on Juniper switch connected to two ports on one Mikrotik router as a bridge and I want to configure the two ports on Juniper to be active and standby or active and passive because this Juniper Switch is stacked for redundancy ...

  • Profile Picture

    RE: MAC-based VLANs

    RADIUS and dot1x configurations can assign VLANs based on the MAC addresses. One sample example configuration is shown below (static MAC configuration, but this should ideally be done by a RADIUS NAC). jcluser@vqfx-re# show interfaces xe-0/0/2 unit ...

  • I don't think it would allow to " use a device's MAC address to assign packets to a VLAN ". Would it? ------------------------------ Pawel Mazurkiewicz ------------------------------

Announcements

  • Connect your switches to the cloud with Mist AI Wired Assurance!

    With this free 90-day trial experience simpler operations, shorter mean time to repair, simplified campus fabrics, and gain visibility into end-user experiences for your wired devices! You will also have full access to AI-driven support via Juniper Support Insights (JSI).

Unanswered Posts

Top Contributors in the Community