I haven't been able to find a specific example for what I'm trying to do, or maybe I'm not understanding the documentation. I've mostly used old BLADEOS switches for this in the past, and am trying to migrate to Juniper EX series switches. On BLADE you'd assign an IP address to a VLAN, enable routing for that, and turn on RIP (and this was in a web page).
I have a network with a bunch of VLANS that get routed in different places. Sometimes I add a new subnet and hang it off a new switch, so this is what I'm trying to do:
Network A (192.168.1.0/24)----> (Trunk with tagged VLANS 100,101,102,103) -----> New Switch ------> (ports with VLANS 100,101,102,103) AND now (ports with VLAN 104). VLAN 104 will be a new subnet, that I want to route on "New Switch" and advertise back up to "Network A" via RIP.
My best understanding from the docs so far is I create a subinterface for a vlan on the trunk port likeset unit 0 vlan-id 104
Then I assign the IP address to the unit?set unit 0 family inet address 126.96.36.199/24
Then I create a static route?set routing-options static route 192.168.1.0/24 next-hop 188.8.131.52
Though it seems more like I need to say if it's for 184.108.40.206/24? So maybe?set routing-options static route 220.127.116.11/24 next-hop 172.16.1.2
Then I need to enable RIP:set protocols rip group rip-group export advertise-routes-through-rip
set policy-options policy-statement advertise-routes-through-rip term 1 from protocol direct
set policy-options policy-statement advertise-routes-through-rip term 1 from protocol rip
set policy-options policy-statement advertise-routes-through-rip term 1 then accept
Am I even close here? Thanks