This is an EX example, also EX does not allow to match on pps only bps
Like Steve posted a policer is what your wanting , but you use it inside your filter.
In your filter term to match ip
from source-address 0/0
then {
policer 3meg;
Original Message:
Sent: 12-15-2021 12:24
From: UJJAL BS
Subject: seeking help for pps limit(per ip) under specific interface
need help about pps limit for per ip under specific interface
device: Juniper MX204
os version: 21.1R1.11
------------------------------
UJJAL BS
------------------------------