Hi everyone,
I have a problem with ERPSv2 on ACX7100.
i am using three node ring , other 2 nodes are from other vendor.
I set ACX as Ring Node (not RPL Owner), the ERPS is not running.
show protection-group ethernet-ring node-state
Ethernet ring APS State Event RPL Owner WTR Timer WTB Timer Guard Timer Operation state
RING1 pending NR No disabled disabled disabled operational
show protection-group ethernet-ring interface
Ethernet ring port parameters for protection group RING1
Interface Control Channel Direction Forward State RPL End SF Admin State
et-0/0/0 et-0/0/0.0 east discarding No Clear IFF ready
et-0/0/1 et-0/0/1.0 west forwarding No Clear IFF ready
show protection-group ethernet-ring aps
Ethernet Ring Request/state RPL Blocked No Flush BPR Originator Remote Node ID
RING1 NR No No 0 Yes NA
My configuration :
set protocols protection-group restore-interval 1
set protocols protection-group guard-interval 10
set protocols protection-group hold-interval 0
set protocols protection-group ethernet-ring RING1 level 7
set protocols protection-group ethernet-ring RING1 compatibility-version 2
set protocols protection-group ethernet-ring RING1 east-interface control-channel vlan 1100
set protocols protection-group ethernet-ring RING1 east-interface control-channel et-0/0/0.0
set protocols protection-group ethernet-ring RING1 west-interface control-channel vlan 1100
set protocols protection-group ethernet-ring RING1 west-interface control-channel et-0/0/1.0
set protocols protection-group ethernet-ring RING1 control-vlan 1100
set protocols protection-group ethernet-ring RING1 data-channel vlan 1000
set protocols protection-group ethernet-ring RING1 data-channel vlan 1200-1209
I have disabled RSTP.
When i test to set ACX as RPL owner : ERPS running normally.
Please need your help to solve this issue.
------------------------------
sdw
------------------------------