Junos OS

 View Only


This community is currently under full moderation, meaning  all posts will be reviewed before appearing in the community. Please expect a brief delay—there is no need to post multiple times. If your post is rejected, you'll receive an email outlining the reason(s). We've implemented full moderation to control spam. Thank you for your patience and participation.

  • 1.  Interfaces Doesn't recognize the VLANs

    This message was posted by a user wishing to remain anonymous
    Posted 06-30-2022 10:25
    This message was posted by a user wishing to remain anonymous

    Hello Everybody!

    I am new to JUNOS and Started to work with their hardware in the few last months,
    I am doing a project in my work (EVE) and started to configure a switch and 2 Routers,
    AR1 is connected to AS1 via TRUNK  with GE-0/0/2 - under it I use router on a stick and configure AE50.1000
    AS1 is connected to the Customer via ACCESS.
    I configured the vlan on the switch and configured the IP's on the routers,
    Problem is that the interfaces haven't connected/recognized the vlan.
    I am adding pictures of everything and of the configurations aswell,
    Please help because I run out of ideas.
    AR & Customer - Junos router
    AS- Junos switch

    AR configurations : 

    AS Configuration:

    Customer configuration:

    Please help guys.

  • 2.  RE: Interfaces Doesn't recognize the VLANs

    Posted 06-30-2022 15:14
    You're connecting a 1G interface (AR1 ge-0/0/2) to a 10G interface (AS1 xe-0/0/1). You need to reconfigure the 10G interface to operate at 1G. I have no idea how this is done in EVE.

  • 3.  RE: Interfaces Doesn't recognize the VLANs

    Posted 07-05-2022 16:03
    you might need...

    set chassis aggregated-devices ethernet device-count 5

    set interfaces ae50 aggregated-ether-options lacp active

    ...also, IIRC, EVE allows mix-matched speeds of interfaces (ge connected to xe)

    Aaron Gould
    Senior Network Engineer