SRX Next-Gen Firewalls

 View Only

Latest Discussion Posts

  • Hi, Are u sure you follow the guide? First connect the Control Link (direct connect)...Make sure control link is up. ..Then do command set chassis cluster cluster-id 1 node x reboot on both node manually. Then both will be reboot and form cluster. ...

  • Hello All, I have a problem with finish setup cluster on two SRX550 devices (firmware version 12.3X48-D105.4). I did everything according to this manual: https://supportportal.juniper.net/s/article/SRX-Getting-Started-Configure-Chassis-Cluster-High-Availability-on-a-SRX550-device?language=en_US ...

  • I want to create a VPN tunnel between sites. To explain my current network configuration please see the attached diagram. Site A has a Juniper firewall SRX345 with a public IP address, and site B has a 4G broadband router with a private IP address. ...

  • Hello, I understand that hubs need to be suggesters, but if you have 2 hubs that you want to interconnect such that they can be redundant suggesters and also connect to each other, is that possible? Each hub has 2 ISP connections and there are multiple ...

  • Hello, I want layer 2 traffic tagged with a 802.1q tag 100 to pass through the SRX transparently towards the device that has its layer 3 gateway IP address configured, is this possible? I am aware I can create an IRB interface and put ports into vlans, ...

Polls


Current Members
564 Members
Hidden Member
community Admin
community Admin