You are right. I just checked and it works. I had been trying to solve the problem for 3 weeks and in the end it was my mistake. I thought ports were read from bottom to top. Thank you very much for your help. ------------------------------ ADRIAN FERNANDEZ ...
There is a mismatch between the configurations and your visual port assignments in the first post. ge-0/0/0 is the physical top port which your diagram shows to be red vlan 1 the port counting starts with 0 and goes top to bottom and left to right. ...
Are you referring to the "Set vlans" command? Attached is a summary of the Vlans configuration .
root# show vlans
I don't know what ...
That all looks correct. Please supply the vlan configuration too.
vlans Grupo2 ------------------------------ Steve Puluka BSEET - Juniper Ambassador IP Architect - DQE Communications Pittsburgh, PA (Metro Ethernet & ISP) http://puluka.com/home ...
Thanks for your reply. This is how I did it before but on ge-0/0/0 but it still doesn't work ( Is it necessary to be on interface ge-0/0/1?) . I enclose the code that appears when I use the "show interfaces" command Grupo1 is vlan1 with id- 100 Grupo2 ...
Lend your voice and make an impact at Juniper. The Innovators Circle is a research-driven, private circle where members share feedback on a wide range of topics to help Juniper leaders make an impact on all business areas (e.g., marketing, products, digital experience, etc.). Members receive opportunities for rewards through e-gift cards and exclusive content.
Juniper is driving a company-wide initiative to further enhance our customers’ experience. Please tell us how we’re doing via a quick video that will be used for internal Juniper viewing only--none of it will be shared publicly!
Use your phone or laptop. It should take about 5-10 minutes, and you can review and re-record any segment at the click of a button.
Thank you in advance!