SRX Next-Gen Firewalls

 View Only

Latest Discussion Posts

  • Profile Picture

    RE: Enabling Ports on XPIM

    The general process for what you want is as follows. The gateway ip address moves from a physical interface to a virtual one vlan.#. <<<< chosen unit number with the family inet address which seems currently on your ge-0/0/2 interface All the interfaces ...

  • Adding the "junoscript" to "allow-commands" statement authorizes the "xml-mode netconf need-trailer" command in newer Junos versions required for establishing the NETCONF session. Tested with 18.4R3-S2 and 19.4R2.6. In addition, one has to extend the ...

  • Hi There! I recently received a 24 port gig-e XPIM for my SRX650. I have been having troubles implementing it into the network. My goal is to have it function as part of the Users zone which is also available on ge/0/0/2 and just have it function as ...

  • Hi, I have a weird problem on an SRX device where an ARP is lost when a specific interface is transitioned from one zone to another. Meaning the initial configuration of the interface was part of the "trust" zone, a cable was plugged in (at his point ...

  • Ok, further investigation shows the DHCP route as secondary, and as [Access-internal/12]. However, clients on the internal irb interfaces are unable to route out via this connection when the primary one goes down. In addition, if I try to ping out from ...

Current Members
476 Members
Hidden Member
community Admin
community Admin