Junos OS

 View Only

If you have a question or a use case, likely there are others out there who are experiencing or worked through the same thing. Don't hesitate to jump in and ask or share your knowledge!

Need additional guidance?  Check out these Juniper Resources.

Day One +Technical BulletinsTechLibrary

Latest Discussion Posts

  • We would need to confirm what policy would apply to the traffic that is allowed. You can look for the active session for that traffic to the /16 when it is permitted and see what policy and details are seen for the session. show security flow session ...

  • Hello, Did you check to see if you have the license loaded on your SRX. I found this to be the problem when I first created my Juniper Secure Connect connection. The IPSEC tunnel won't start unless the license is there. Hope This Helps ------------------------------ ...

  • The dns rule would be from the zone making the request to the zone where the dns request is forwarded. I would guess the rule above is in the wrong direction, expecting the request to come from the trust zone to the untrust one. If your dns rule is ...

  • Hi, there I would like to migrate from Pulse Secure to Juniper Secure Connect. In J-Web wizard, when setting External Interface of Local Gateway, there is no ge-0/0/0 or pp0.0 in the drop list (external interface was set to pp0.0 for Pulse Secure). Are ...

  • Hello, So Juniper works a little bit different. Typically you create a VLAN and then assign an IRB to which acts like a cisco switch with vlan routing. Try this: zones { security-zone trust { tcp-rst; interfaces { irb.10 { host-inbound-traffic { system-services ...

Polls


Announcements