Junos OS

 View Only

If you have a question or a use case, likely there are others out there who are experiencing or worked through the same thing. Don't hesitate to jump in and ask or share your knowledge!

Need additional guidance?  Check out these Juniper Resources.

Day One +Technical BulletinsTechLibrary

Latest Discussion Posts

  • Hello, So Juniper works a little bit different. Typically you create a VLAN and then assign an IRB to which acts like a cisco switch with vlan routing. Try this: zones { security-zone trust { tcp-rst; interfaces { irb.10 { host-inbound-traffic { system-services ...

  • Hello Juniper Geniuses, So, recently I placed a Juniper SRX 340 between my remote sites and my main network. Due to security concerns, I cannot configure a permit "any" rule for my polices between these two locations so each policy application is configured ...

  • This message was posted by a user wishing to remain anonymous I have an SRX340 with a simple setup: all traffic interfaces are in the global zone, all security policies apply to that zone, and all security policies are set to log. I have static routes ...

  • Sorry, I forgot this detail. Here is my routing table. I get the neighbor by OSPF show route inet.0: 2 destinations, 2 routes (2 active, 0 holddown, 0 hidden) + = Active Route, - = Last Active, * = Both 186.237.112.16/28 *[Direct/0] 15:08:37 ...

  • Where is the vpls neighbor on the network? The configuration above would only work with two directly connected devices if there is anything between the two vpls neighbors you will also need to configure an LSP and expand to targeted LDP signaling. ------------------------------ ...

Polls


Announcements