Data Center

 View Only

If you have a question or a use case, likely there are others who are experiencing or worked through the same thing. Don't hesitate to jump in and ask or share your knowledge!

Need additional guidance?  Check out these Juniper Resources.

TechLibrary Data Center Design Center The Feed

Latest Discussion Posts

  • thanks so much !!

  • Two sub interface, One for the fabric, one for WAN. The VXLAN fabric should be so isolated it can, does not need any connection to the other routing-instance. There are number of different ways to connect inter DCs. Following configuration example gives ...

  • So you have two links to the core router, one for inet.0, the other for the routing-instance. The traffic routing to each other is via the core. right ? thanks so much !!

  • The Junos release you using, should be stable for VXLAN. From the routing-instance with BGP as the dynamic routing protocol to the core router. With this setup is very easy to separate different traffic types. Example, you can have one instance for internet, ...

  • Junos: 21.2R2-S1.5 flex How does your vxlan L3 communicate to the networks outside vxlan ? Our qfx5110 does not serve spine and leaf, just serves DCI. It needs to host both normal vlan and vxlan. thanks !!

Latest Shared Files

Log in to see this information

Either the content you're seeking doesn't exist or it requires proper authentication before viewing.

Polls


Announcements

Current Members
322 Members