Data Center

 View Only

If you have a question or a use case, likely there are others who are experiencing or worked through the same thing. Don't hesitate to jump in and ask or share your knowledge!

Need additional guidance?  Check out these Juniper Resources.

TechLibrary Data Center Design Center The Feed

Latest Discussion Posts

  • I have MX204 PPPoE customers over 1800 located in different sites. I can extract the count manually and individual site through the command "show subscriber vlan-id 9002 | count". But I need to make a Table extracting output from different vlans and the ...

  • Hi guys, Today I just enable IPv6 in LDP but IPv6 neighbor can't be established When I deactivate re-protection firewall filter it's works well. So I really think it's a problem with firewall filter but I checked everything is correct. I was struggling ...

  • thanks so much !!

  • Two sub interface, One for the fabric, one for WAN. The VXLAN fabric should be so isolated it can, does not need any connection to the other routing-instance. There are number of different ways to connect inter DCs. Following configuration example gives ...

  • So you have two links to the core router, one for inet.0, the other for the routing-instance. The traffic routing to each other is via the core. right ? thanks so much !!

Latest Shared Files

Log in to see this information

Either the content you're seeking doesn't exist or it requires proper authentication before viewing.

Polls


Announcements

Current Members
337 Members
Hidden Member
community Moderator