View Only

If you have a question or a use case, there are likely others experiencing or who worked through the same thing. Don't hesitate to jump in and ask or share your knowledge!

Need additional guidance?  Check out these Juniper Resources.

Knowledge Base Day One+ Technical Bulletins

Latest Discussion Posts

  • Hi all, I'm starting a project for introducing IPv6 routing into our network. We have several Juniper devices in the path that need IPv6 enabled on. The devices are in the following: MX80 router -> EX4600 VC switch -> SRX4100 -> EX4300 VC switch ...

  • Profile Picture

    RE: Firewall Filter

    For traffic that has a source or destination of the Junos device itself we apply the firewall filter to the loopback address and this then applies to all traffic for the device. These are called protect RE filters. There is a full discussion on creating ...

  • I need to add QnQ VLAN to an existing trunk port on a QFX5100. I have a EX4200 -> MX480 - > QFX5100 Here are the existing Interface configuration on the QFX5100 set interfaces ae4 aggregated-ether-options no-flow-control set interfaces ae4 ...

  • Is it possible to have a 100gig port accecpt a 40gig sfp with just plug and go ? ------------------------------ DONALD DAEHNERT ------------------------------

  • Junos has a built in feature to execute scripts on a schedule called event automation. You create either a time of day or time interval trigger and then run the script when it occurs. event-options generate-event { testEvent time-of-day "10:42:00 ...



  • Elevate Community Updates

    We are making improvements to the Community based on your feedback. Keep an eye out for updates as they are implemented. 

    Please give us feedback any time by posting in Community Talk.