Found the answer.
you simply add the word 'distance' to the framed-route:
So in my example if I wanted to change it from the default '13' to 200 with a cost of 250 then it would be as follows:
10.10.10.0/24 192.168.1.1 250 distance 200
Original Message:
Sent: 01-05-2021 15:59
From: Unknown User
Subject: Change a subscriber access route from a preference of 13?
I can change the cost of a route being entered into the routing table by adding the cost at the end of the route for example:
10.10.10.0/24 192.168.1.1 250
I then see this with a cost of 250, but the preference of the access route is still set to it's default of '13' and I cannot get this changed.
my dynamic profile has the below lines:
set dynamic-profiles DYN-PROF-1 routing-instances "$junos-routing-instance" routing-options access route $junos-framed-route-ip-address-prefix next-hop "$junos-framed-route-nexthop"
set dynamic-profiles DYN-PROF-1 routing-instances "$junos-routing-instance" routing-options access route $junos-framed-route-ip-address-prefix metric "$junos-framed-route-cost"
set dynamic-profiles DYN-PROF-1 routing-instances "$junos-routing-instance" routing-options access route $junos-framed-route-ip-address-prefix preference "$junos-framed-route-distance"
set dynamic-profiles DYN-PROF-1 routing-instances "$junos-routing-instance" routing-options access route $junos-framed-route-ip-address-prefix tag "$junos-framed-route-tag"
Which I believe is correct but I cannot seem to format the framed-route in such a way that the preference is being changed.
Cost is fine, I can also tag a route but I just cant change the preference :/
Thanks