Data Center

 View Only

IMPORTANT MODERATION NOTICE

This community is currently under full moderation, meaning  all posts will be reviewed before appearing in the community. Please expect a brief delay—there is no need to post multiple times. If your post is rejected, you'll receive an email outlining the reason(s). We've implemented full moderation to control spam. Thank you for your patience and participation.



VTEP IP questions

This thread has been viewed 7 times
  • 1.  VTEP IP questions

    Posted 12-01-2021 05:43
    If the remote VTEP has multiple loopback addresses with one defined as primary.  In local VTEP,  the following command should list only remote primary loopback IP, or all the loopback IPs ?

    If multiple remote loopback IPs are listed, any issues  will occur ?

    root@vQFX-2# run show ethernet-switching vxlan-tunnel-end-point remote
    Logical System Name       Id  SVTEP-IP         IFL   L3-Idx    SVTEP Mode
    <default>                 0   192.168.1.2      lo0.0    0
     RVTEP-IP         IFL-Idx   NH-Id    RVTEP Mode
     192.168.1.1      574       1782         RNVE
        VNID          MC-Group-IP
        104           0.0.0.0
        103           0.0.0.0
        102           0.0.0.0
        101           0.0.0.0
     RVTEP-IP         IFL-Idx   NH-Id    RVTEP Mode
     192.168.1.10     573       1780         RNVE
        VNID          MC-Group-IP
        104           0.0.0.0
        102           0.0.0.0
        103           0.0.0.0
        101           0.0.0.0
    ​

    both 192.168.1.1 and 192.168.1.10 are the loopback addresses on the same remote VTEP. I have the above output on vQFX 18.4.

    Any documentation for this ?

    thanks !!