Hello Deepak,
this depends on the device, some devices bring the link down if Autoneg fails, some not. So bringing the interface down by changing the Autoneg status is not a reliable method.
------------------------------
------------------------------
If my answer provides the solution, please mark my post as "Best Answer".
If you think my answer helps, please "Recommend" my post.
------------------------------
Original Message:
Sent: 02-02-2021 04:08
From: Unknown User
Subject: Bringing a link down via CLI.
Thanks F1ght3r.
Can auto-negotiation failure bring a link down in the same way? That's what I'm currently trying to do.
Thanks,
Deepak
Original Message:
Sent: 02-02-2021 03:40
From: Daniel
Subject: Bringing a link down via CLI.
Hello Deepak,
you can bring down the port with "set interfaces ge-0/0/0 disable"
------------------------------
------------------------------
If my answer provides the solution, please mark my post as "Best Answer".
If you think my answer helps, please "Recommend" my post.
Original Message:
Sent: 02-02-2021 01:08
From: Unknown User
Subject: Bringing a link down via CLI.
Hi .
Assuming my GE port has a healthy cable plugged into it, is there any way I can bring the 'Link' column to say down instead of up?
lab@vSRX-1> show interfaces ge-0/0/0 terse
Interface Admin Link Proto Local Remote
ge-0/0/0 up up
I configured the port for half duplex and the 'Link' remained up.
Thanks,
Deepak