View Only


This community is currently under full moderation, meaning  all posts will be reviewed before appearing in the community. Please expect a brief delay—there is no need to post multiple times. If your post is rejected, you'll receive an email outlining the reason(s). We've implemented full moderation to control spam. Thank you for your patience and participation.

  • 1.  VCP ports

    Posted 04-04-2022 05:41
    I need to assure that we can use the uplinks ports in 10 G speed in EX 3400 for example to run as VCP, instead of the preconfigured one.
    In this case we will use DAC 10 G, does any one try this before ..

  • 2.  RE: VCP ports

    Posted 04-11-2022 05:50
    The 10G sfp ports are supported for VCP operation.  The obvious limitation is the lower amount of traffic that can be supported by the link.


    By default, the QFSP+ uplink ports on EX3400 switches are configured as VCPs, or you can configure any SFP+ uplink module ports on EX3400 switches as VCPs. You can't use uplink ports with SFP tranceivers as VCPs to connect EX3400 switches into a Virtual Chassis.

    Steve Puluka BSEET - Juniper Ambassador
    IP Architect - DQE Communications Pittsburgh, PA (Metro Ethernet & ISP)

  • 3.  RE: VCP ports

    Posted 04-11-2022 18:42
    Thank you spuluka