Switching

 View Only

IMPORTANT MODERATION NOTICE

This community is currently under full moderation, meaning  all posts will be reviewed before appearing in the community. Please expect a brief delay—there is no need to post multiple times. If your post is rejected, you'll receive an email outlining the reason(s). We've implemented full moderation to control spam. Thank you for your patience and participation.



Enable out of band management access on SRX345 and EX3400 using a switch

  • 1.  Enable out of band management access on SRX345 and EX3400 using a switch

    Posted 12-22-2021 20:16
    Hi there,
    I have the following topology as attached in the image below where I have one firewall and one switch connected to the management switch. I want to set up an OOBM (Out of Band Management) service for both Juniper devices. I am able to access the Management switch using public IP address. Now I want to access both Juniper SRX345 and EX3400 via SSH using a Management switch.


    Here is the following configuration I have set up for both devices.

    SRX345 firewall:

    root@SRX-345# show interfaces fxp0
    unit 0 {
    family inet {
    address 15.0.0.1/24;
    }
    }

    EX3400 switch:

    root@SEX3400# show interfaces me0
    unit 0 {
    family inet {
    address 15.0.0.2/24;
    }
    }


    Both devices have SSH and telnet services enabled. I am not sure, do I need a next-hop address on both devices or any other settings are required. Please help me in that regard. Thanks







    ------------------------------
    ABDUL WAHAB QURASHI
    ------------------------------