Switching

 View Only

IMPORTANT MODERATION NOTICE

This community is currently under full moderation, meaning  all posts will be reviewed before appearing in the community. Please expect a brief delay—there is no need to post multiple times. If your post is rejected, you'll receive an email outlining the reason(s). We've implemented full moderation to control spam. Thank you for your patience and participation.



Expand all | Collapse all

QFX5100 per-unit filter policy applies first filter to all units irrespective of configuration

This thread has been viewed 10 times
  • 1.  QFX5100 per-unit filter policy applies first filter to all units irrespective of configuration

    Posted 01-16-2022 15:07
    I've noticed that on a QFX5100, on an aggregated interface where a policer is applied to various units, only the first policer is used. This is obviously a problem for many reasons.

    I cannot find any reference to such a limitation in the JunOS documents for a QFX5100.

    Any ideas? Thanks.

    Relevant configuration is as follows:

    set interfaces ae2 per-unit-scheduler

    set interfaces ae2 flexible-vlan-tagging

    set interfaces ae2 encapsulation flexible-ethernet-services

    set interfaces ae2 aggregated-ether-options minimum-links 1

    set interfaces ae2 aggregated-ether-options lacp active

    set interfaces ae2 unit 2003 family ethernet-switching interface-mode trunk

    set interfaces ae2 unit 2003 family ethernet-switching vlan members VLAN1

    set interfaces ae2 unit 2003 family ethernet-switching filter input FILTER2

    set interfaces ae2 unit 2003 family ethernet-switching filter output FILTER2

    set interfaces ae2 unit 2312 family ethernet-switching interface-mode trunk

    set interfaces ae2 unit 2312 family ethernet-switching vlan members VLAN2

    set interfaces ae2 unit 2312 family ethernet-switching filter input FILTER2

    set interfaces ae2 unit 2312 family ethernet-switching filter output FILTER2

    Policer configuration is:

    set firewall family ethernet-switching filter FILTER1 term 1 then policer 100M

    set firewall family ethernet-switching filter FILTER2 term 1 then policer 1500M



  • 2.  RE: QFX5100 per-unit filter policy applies first filter to all units irrespective of configuration

    Posted 04-09-2022 08:31
    No one has experienced this issue before or no one has any alternative suggestions?