Yes all works fine, it was completed setup.
I can Login also wenn i plug in in the Management port from other Computer and enter Switch IP.
Problem was i got this Switch and have no data from them.
I try USB to connect, ok don´t work.
Then i try Console Port and connect to serial, works, but i leave USB connected.
Now i plug in power cable and one fan works, but not loud.
Plug in USB Switch running and i can connect with serial.
All works but only with connected USB and running Laptop.
I have add some screens, maybe helps.
cu
------------------------------
SVEN COLOMBO
------------------------------
Original Message:
Sent: 12-03-2020 17:09
From: Unknown User
Subject: EX2200
Hi Sven,
Can you confirm if the ezsetup was completed properly, as the below link state,
https://kb.juniper.net/InfoCenter/index?page=content&id=KB10908
I mean, were you able to set hostname, password and remain settings? or it was not completed?
Regards,
Jeff
Original Message:
Sent: 12-03-2020 14:00
From: SVEN COLOMBO
Subject: EX2200
Hi,
i have a Juniper EX2200 and have reset them to factory defaults and run ezsetup.
Now i must connect always the USB port to my Notebook that the EX2200 run.
What´s wrong ?
best
Sven
------------------------------
SVEN COLOMBO
------------------------------