Junos allows connections on port 22 for netconf but is also listening on port 830.
You can see this on your device using:
show system connections | match 830
------------------------------
Steve Puluka BSEET - Juniper Ambassador
IP Architect - DQE Communications Pittsburgh, PA (Metro Ethernet & ISP)
http://puluka.com/home------------------------------
Original Message:
Sent: 04-14-2021 17:02
From: Unknown User
Subject: netconf port question
How can I enable netconf to listen on the default port 830 ?
I tested without netconf configuration, it listens on port 22 after I enabled ssh.
If I configured "set system services netconf ssh", netconf listens on port 22,too.
The training materials say netconf listens on port 830 by default with you enable ssh or configure "set system services netconf ssh".
Anything I missed ?
thanks !!