Hi what software are you using to run de vmx ? if you are using for example eve-ng the interfaces are ge no xe and the first two port are for internal use.
could you share the
show chassis hardware
show chassi fpc
show interfaces terse media
Best regards
------------------------------
JHONATHAN ESPINO
------------------------------
Original Message:
Sent: 05-25-2022 09:32
From: Anonymous User
Subject: LACP not working in Juniper MX80 Router.
This message was posted by a user wishing to remain anonymous
Hello,
I'm new at juniper. I tried to configure LACP on Juniper MX-80 Router on both sites. But it's not working.
On Router-1:
set interfaces xe-0/0/0 gigether-options 802.3ad ae0
set interfaces xe-0/0/1 gigether-options 802.3ad ae0
set interfaces ae0 aggregated-ether-options lacp active
set interfaces ae0 aggregated-ether-options lacp force-up
set chassis aggregated-devices ethernet device-count 1
On Router-2:
set interfaces xe-0/0/0 gigether-options 802.3ad ae0
set interfaces xe-0/0/1 gigether-options 802.3ad ae0
set interfaces ae0 aggregated-ether-options lacp force-up
set chassis aggregated-devices ethernet device-count 1