Switching

I'm not sure I follow all the configuration here. But I see two things to check on. On the SSG cluster that is flapping master/slave roles this can be caused by issues with the HA connection between the two by configuration or cabling. Or the nsrp ...

This message was posted by a user wishing to remain anonymous Hi, Erdem! Remember that vQFX is splitted in two: RE and PFE. So, you should make sure to connect them through internal interface and wait until they synchronize. It can take from 3 to ...

Hello, I need to replace old SSG140 with SRX345 HA. My idea is to user 2 x Standalone EX2300 as external switches with multiple vlans to be able to connect same time both SSG and SRX. In that way I can try and test SRX345 configuration and revert ...

Also note: You must not configure both data and voice on the same VLAN. If you configure data and voice on the same VLAN, the configuration will not be accepted. If you have enabled 802.1X authentication on your switch and: The voice VLAN you ...

Ashton, Try using the Juniper-VoIP-VLAN VSA in your RADIUS attributes in ISE. Here is an example on how to configure it. https://www.juniper.net/documentation/us/en/software/nce/nce-213_ex_and_cisco_ise/topics/topic-map/nce-213-ex-series-switch-cisco-ise.html ...

When doing upgrades on Junos there are limits to how many major and minor versions you can jump so there would be intermediate steps in your case. To determine the exact path you would need to start by reviewing the release notes of the final version. ...

I was reading the request system zeroize media cli reference and it states a mouth full for for caveats. In short, it recommend you remove and disconnect each of those members from the Virtual Chassis or VCF, and then run the command on each isolated ...