Looks like your configuration is not complete and also should be at the unit level and not at the base interface per the example here.
https://www.juniper.net/documentation/us/en/hardware/srx300-srx550-hm/topics/topic-map/mpim-lte.html------------------------------
Steve Puluka BSEET - Juniper Ambassador
IP Architect - DQE Communications Pittsburgh, PA (Metro Ethernet & ISP)
http://puluka.com/home------------------------------
Original Message:
Sent: 04-20-2022 13:32
From: Unknown User
Subject: SRX340 - cl-2/0/0 - Admin Down.
Hi,
The cl-2/0/0 interface showing admin down, though it is not disable on config level.
is there a command to disable / enable under pfe mode. (> start shell pfe network fwdd)
admin@xxx-fw1> show interfaces cl-2/0/0
Physical interface: cl-2/0/0, Administratively down, Physical link is Up
Interface index: 161, SNMP ifIndex: 555
Type: LTE, Link-level type: Ethernet, MTU: 1504, Speed: LTE MODEM
Device flags : Present Running
Interface flags: Admin-Test Link-Layer-Down Point-To-Point SNMP-Traps Internal: 0x0
admin@xxx-fw1> show configuration interfaces cl-2/0/0
dialer-options {
pool 1 priority 100;
}
act-sim 1;
cellular-options {
sim 1 {
radio-access automatic;
}
sim 2 {
radio-access lte-only;
}
}
------------------------------
Regards,
Bharath
------------------------------