Hi Prasanth,
The error indicates that node1 is in unhealthy state because of some monitoring failure and hence the priority is 0. You may check output of below commands to understand the root cause.
show chassis alarms
show system core-dumps
show chassis fpc pic-status
show chassis cluster status
show chassis cluster interfaces
show chassis cluster information detail
show log messages (look for any alarm/error etc when the issue reported)
Thanks,
Nellikka
Original Message:
Sent: 03-11-2022 20:46
From: Unknown User
Subject: SRX-5800 manual chassis cluster switch over is not happening
Manual chassis cluster switcover is not happening in SRX-5800 and getting error shown below.
"Manual failover is not permitted as readiness check failed redundancy-group 1 on node1 priority is 0 Use 'force' option at the end to ignore this check"
Please provide a solution to switch over