Automation

 View Only
last person joined: 3 days ago 

Ask questions and share experiences about Apstra, Paragon, and all things network automation.

  • 1.  Question on missing Apstra system IDs

     
    Posted 02-15-2025 05:52

    Hi.

    I am using the Juniper Study Bundle to prepare for my JNCIE-DC.  However, 2 out of 5 times I am unable to create a blueprint because of missing system IDs when I try to assign system IDs to leaf and spine devices. (See image below). This in spite of the 'offbox device agents' being 'connected' and 'acknowledged'.

    The other 3 out of 5 times the system ids are present and I am able to select them and complete the blueprint. 

    I have so far been unable to figure out what I'm doing wrong whenever I'm unable to assign system IDs to my devices due to missing system IDs in the drop down menu (See image below). 

    Any pointers?

    Many thanks,

    Deepak



  • 2.  RE: Question on missing Apstra system IDs

    Posted 04-06-2025 23:03
    Edited by RYOTA KOSAKA 04-07-2025 00:03

    Hi

    In chapter1 task1.1, you create "device profile" named jncie-vqfx.
    You may use it for "Interface Map" of jncie-spine and jncie-leaf.
     
    If so, you must check spine and leaf devices' device profile are "jncie-vfqx" (not Juniper-vQFX(original one),
    because they match both of jncie-vqfx and Juniper-vQFX.
     
    Sometimes jncie-vfqx was selected and sometimes Juniper-vQFX was selected, so I needed to fix it.



    ------------------------------
    RYOTA KOSAKA
    ------------------------------

    Original Message