From the error that you are getting "WAN with overlapping interface already exists", indicates that you already have a WAN entry created called "WAN" that contains ge-0/0/0. So before you can create an entry called "WAN-local" with ge-0/0/0-1 you will first need to remove ge-0/0/0 from the WAN entry.
Regards,
Original Message:
Sent: 04-01-2025 07:02
From: KAUSHIK RAY
Subject: Port Bonding using Juniper
I am asking this as when I am trying to do port aggregation on the WAN interfaces 0 and 1, I am getting this error. Any advise will be much appreciated
------------------------------
KAUSHIK RAY
Original Message:
Sent: 04-01-2025 05:24
From: KAUSHIK RAY
Subject: Port Bonding using Juniper
Hello
I am trying to figure out a way to bond WAN interfaces so that the WAN links can be bonded together to gain aggregated speeds across. I have gone through options on LaG / LaCP.
Has this been tried with SSRs using Mist yet? Does this work in actual world?
------------------------------
KAUSHIK RAY
------------------------------