Is this method supposed to help in capturing mpls packets ? I aim to capture traffic that contains L2VPN & L3VPN labeled packets like this :
https://packetlife.net/media/captures/EoMPLS_802.1q.pcap.cap
https://packetlife.net/media/captures/EoMPLS.cap
Thanks in advance for your kind help.
------------------------------
Jeremie Rouzet
------------------------------
Original Message:
Sent: 07-31-2023 11:31
From: Jeremie Rouzet
Subject: Packet capture on a MPLS network
Thank you @spuluka !
------------------------------
Jeremie Rouzet
Original Message:
Sent: 07-21-2023 06:34
From: spuluka
Subject: Packet capture on a MPLS network
Here is the kb on setting up packet capture for branch SRX devices.
https://supportportal.juniper.net/s/article/Includes-video-How-to-create-a-PCAP-packet-capture-on-a-SRX-branch-device?language=en_US
------------------------------
Steve Puluka BSEET - Juniper Ambassador
IP Architect - DQE Communications Pittsburgh, PA (Metro Ethernet & ISP - Retired)
http://puluka.com/home
Original Message:
Sent: 07-19-2023 12:12
From: Jeremie Rouzet
Subject: Packet capture on a MPLS network
Hi,
I have a couple of SRX300 acting as PEs on which i would like to perform a packet capture. I especially want to capture packets related to a xconnect i created between a SRX300 and a Cisco ISR. On each access side of both PEs i have a host.
I would like the packet capture to be performed on the mpls interface (towards the backbone) of one SRX300 so i can sample a couple of frames including some that brings a simple ping i am performing between the two hosts connected to each other thanks to the L2circuit.
I tried a couple of scenario but none of them helped.
Thanks in advance for your kind help.
Regards,
Jerems.
------------------------------
Jeremie Rouzet
------------------------------