I have 4 sites that show a switch or device not under the core fiber switch in the Topology view. Two are switches, one is an IP camera, and one is a Dell computer. Nothing but switches are connected to the core fiber switch so the topology should flow from the core fiber to a number of IDF racks with switches and then ,in some racks , to a secondary switch in the rack if I didn't have a direct run for both switches back to the core fiber switch. I would like to figure out why these four devices show up outside the physical connection flow on the Topo view.
How does the Topo view determine how it's connections should show up?
------------------------------
JOHN WILLIAMSON
------------------------------